Evinrude E-Tec, Руководство оператора

Страница: 38 / 84

36
Using Your Evinrude E-TEC Outboard
The following warnings may appear on the engine monitor gauge.
“LOW OIL”
“NO OIL”
Your outboard is designed to run in “get home” mode for up to five hours in the event you run out
of oil. Refill the oil tank. Prime oil system. Refer to
Priming the Oil System
on page 17.
“WATER TEMP” or “HOT”
“CHECK ENGINE” or “CHK ENG”
*Speed Adjusting Failsafe Electronics
A
WARNING
In the S.A.F.E. mode, engine speed is limited. Under certain conditions, the engine’s
limited speed may reduce maneuverability of your boat. If the S.A.F.E. mode is acti-
vated and you are unable to correct the problem, seek assistance and/or return to
safe harbor. Serious engine damage, engine shutoff, and/or reduced maneuverability
may be imminent.
Symptom Oil in the oil tank is at reserve level (about 1/4 full)
Result EMM will activate low oil light or display warning
Action
• Fill the oil tank with recommended outboard oil as soon as possible to avoid empty-
ing the tank. The outboard has a limited amount of time of normal running time be-
fore “NO OIL” condition occurs. Refer to
Filling the Oil Tank
on page 17. Always
refill the oil tank with recommended oil as soon as possible.
Symptom There is an oil delivery problem
Result EMM will activate S.A.F.E.* mode
Action
• If the oil tank is empty, add the recommended oil.
• If the oil tank is not empty, seek assistance and/or return to safe harbor.
Symptom The engine is overheating
Result EMM will activate S.A.F.E.* mode
Action
• A continuous light with S.A.F.E. mode — The EMM has identified an overheating
condition. Check the water pump indicator for a steady stream of water. Shut OFF
the engine. Clear the water intake screens of any debris. If the overheat condition still
exists, the engine will operate in “get home” mode. Return to harbor immediately.
• A flashing light — The EMM has identified a damaging overheating condition. The
engine will not operate. Allow the engine to cool for 20 minutes and return to harbor
immediately. See your Dealer.
Symptom An abnormal operating condition
Result EMM will activate check engine light or display warning
Action
• A flashing light — The EMM has identified an abnormal operating condition related
to the fuel system. The engine will shut OFF and cannot be restarted.
• A continuous light with S.A.F.E. mode — The EMM has identified a problem with
the outboard. Seek assistance and/or return to harbor. See your Dealer.
• A continuous light without S.A.F.E. mode — The EMM has identified a problem
that should be addressed by your Dealer as soon as practical to avoid operational
difficulties.
A
WARNING
If the outboard shuts OFF and the “CHECK ENGINE” or “CHK ENG” light is flashing,
the outboard cannot be restarted. A hazardous fuel condition may exist. Seek assis-
tance to return to port. See your Dealer.