Evinrude E-Tec, Руководство оператора

Страница: 22 / 84

20
Using Your Evinrude E-TEC Outboard
FUEL SYSTEM INFORMATION
In the United States, the U.S. EPA requires
"low permeability" fuel hose, fuel primer
bulbs, portable fuel tanks and fuel caps to be
used with outboard engines.
IMPORTANT: Fuel distribution hoses in the
boat must deliver fuel at a specific flow rate.
Minimum inside diameter of fuel hoses must
be 3/8 in. (9 mm).
Fuel systems with built-in tanks, particularly
those that include antisiphon valves and filter/
primer units, may have restrictions not allow-
ing the engine fuel pump to deliver sufficient
fuel under all conditions. This can result in a
loss of performance. If a performance prob-
lem exists, see your Dealer.
Fuel Filters
A boat-mounted water-separating fuel filter
assembly will help prevent water and other
contaminants from entering the engine fuel
system.
Use of a boat mounted water-separating fuel
filter is highly recommended on all boats.
Boat-mounted water-separating fuel filter as-
semblies must meet the required fuel flow and
filter specification. Refer to Boat-Mounted
Fuel Filters on page 57.
Fuel Hose Connections
1) If the fuel hose is disconnected for any rea-
son, seal it to prevent spillage. Cap the fuel
fitting to prevent contamination.
2) Connect the fuel hose to the 3/8 in. (9 mm)
fuel fitting. Fasten hose securely with
clamp (18.5 mm) from owner’s kit.
3) Squeeze fuel primer bulb, outlet end up,
until firm.
Fuel Connector
If equipped, disconnect fuel hose connectors
from the engine’s fuel connector when the en-
gine is not in use.
Fuel System Priming
If the outboard is run out of fuel, refill the fuel
tank and squeeze the primer bulb until firm.
A WARNING
If engine is equipped with a quick-dis-
connect fuel hose, you MUST disconnect
the fuel hose from the engine and the
fuel tank to prevent fuel leaks:
• Whenever the engine is NOT being
used
• Whenever the engine is being trailered
• Whenever the engine is in storage
NOTE: A small amount of fuel may be
released when the fuel connector is dis-
connected.
Store portable fuel tanks in well-venti-
lated areas, away from heat sources and
open flames. Close the vent screw of the
fuel tank cap, if equipped, to prevent
escape of fuel or fuel vapors which could
accidentally ignite. Do not allow discon-
nected fuel hoses to leak fuel.
1. Fuel hose – 3/8 in. (9 mm) 002018
1. Fuel connector
007004
1
1