Evinrude E-TEC G2, Руководство пользователя

Страница: 25 / 92

23
Operation
Safety Information Engine Starting / Stopping - Tiller
Models
Refer to the Pre-Ride Inspection on page 48.
Complete the inspection before using your
Evinrude E-TEC outboard.
Be sure the water intake screens are below
the water surface.
Connecting the Fuel Hose
Connect the fuel hose to the fuel connector.
If equipped, open vent screw on fuel tank cap.
Squeeze fuel primer bulb, outlet end up, until
firm.
Engine Cut–off Switch
The engine cut–off switch is on the steering
handle. Use of the engine cut–off switch fea-
ture is highly recommended on all boats.

DANGER
Serious injury or death can result from
contact with a rotating propeller or mov-
ing boat and outboard.
Propeller blades can be sharp and the
propeller can continue to turn even after
the engine is off.
Assure the engine propeller area is clear
of people and objects before starting
engine or operating the boat.
Be alert of people in the water.
Always shift the outboard to NEUTRAL
and shut off the engine immediately
when your boat is in an area where there
might be people in the water.
 DANGER
DO NOT run the engine indoors or with-
out adequate ventilation or permit
exhaust fumes to accumulate in confined
areas. Engine exhaust contains carbon
monoxide which, if inhaled, can cause
serious brain damage or death.

WARNING
The engine cover is a machinery guard.
DO NOT operate your outboard with the
cover off unless you are performing
maintenance. Be careful to keep hands,
hair, and clothing clear of all moving
parts. Contact with moving parts could
cause injury.

WARNING
Be familiar with the waters you are oper-
ating in. The gearcase of this outboard
extends below the water surface and
could potentially come in contact with
underwater obstructions. Contact with
underwater obstructions may result in
loss of control and personal injury.
NOTICE
You MUST supply water to the engine
before attempting to start it. Engine dam-
age can occur quickly.
1. Fuel connector 007004
1