[Meggy Jr RGB]
[18]
STEP 16: Mounting the battery box with velcro
Part
#28
, the
last part
, is an adhesive Velcro strip
A strip of velcro with high-strength adhesive is provided to attach
the battery box to the back side of the Meggy Jr circuit board.
And done!
Velcro strips in place!
Before
adding the Velcro...
(1) Test your Meggy Jr to make sure
that it’s working correctly,
(2) Trim very short the leads of components that
stick up where the velcro will go, and
(3) Figure out exactly where you’ll be routing the
battery box wires.
If you have not shortened the leads from the battery
box, you can route them under the velcro as shown to
take up some of the slack and provide strain relief.
When you are ready, attach the hook side of the velcro
to the battery box-- the side
without
the switch-- and the
loop side to the circuit board.
