EVGA nForce 3 250, Руководство пользователя

Страница: 13 / 54

13
Installing the AMD Athlon64 754-pin CPU
This motherboard provides a 754-pin surface mount, Zero Insertion
Force (ZIF) socket, referred to as the mPGA754 socket which supports
the AMD Athlon64 processor in the 754 Pin package utilizes Flip-Chip
Pin Grid Array package technology.
The CPU that comes with the motherboard should have a cooling FAN
attached to prevent overheating. If this is not the case, purchase the
correct cooling FAN before turning on the system.
WARNING: Be sure that there is sufficient air circulation across the
processor’s heatsink. In addition, ensure the CPU cooling FAN is
working correctly; otherwise it may cause the processor and
motherboard to overheat which could cause damage to the system.
An auxiliary cooling FAN may be installed if necessary.
To install the CPU, follow the procedures below:
1. Turn off your system and remove its cover.
2. Locate the ZIF socket and open it by first pulling the lever
sideways away from the socket then upward to a 90-degree
angle.
3. Insert the CPU with the correct orientation as shown below.
4. Replace the lever to its original position.
Note: Locate the notched corner and place the CPU in the socket
accordingly. Because the CPU has a corner pin for two of the four
corners, the CPU will only fit in the orientation as shown.
Installing the Memory
This motherboard has two 184-pin DDR Dual Inline Memory Modules
(DIMM) slots for DDR memory. The minimum memory size for this
motherboard is 64MB and expands to a maximum memory size of
2.0GB of DDR SDRAM.
CPU ZIF mPGAB Socket
Golden Arrow
Socket 754