3067VIP10G Series User Manual
JPEG2000 Advanced Compact Multi-Image Display Processors
Revision 0.1
Page 17
IGMP Source Select:
This control allows the user to add an IGMP Source IP address from one of the
six available slots.
Input IGMPv3 Source-Specific Multicast (SSM) Control:
This control allows the user to specify a
Source multicast address to include/exclude from IGMPv3. Up to 6 source addressed can be specified.
Video PID Select:
This parameter allows the user to select which video PID will be embedded by the
decoder into the video output, and can only be applied when
Program Tuning Mode
is set to PID
Select. Range for this value can be from 2 to 8190. When this setting is applied, if any of the selected
PIDS have been duplicated the user will be alerted with an ‘error’ message.
Note: 0, 1, and 8191 are reserved PIDS in MPEG so they are not included within
the value range.
Audio Select:
This drop down box allows the user to select the specific Audio PID from audio 1
through 8, being configured for AES settings on the MUX Control Output.
Audio PID Select for Output:
This parameter allows the user to select which audio PID will be
embedded by the decoder into the video output, and can only be applied when
Program Tuning Mode
is set to PID Select. Range for this value can be from 2 to 8190. When this setting is applied, if any of
the selected PIDS have been duplicated the user will be alerted with an ‘
error
’ message.
Note: 0, 1, and 8191 are reserved PIDS in MPEG so they are not included within
the value range.
PCR PID:
This parameter allows the user to set the PID for PCR data being sent on ENC J2K and ENC
10bit 4:2:2 H264. Range for this value can be from 16 to 8190.
VANC PID:
This parameter allows the user to set the PID for VANC data being sent on ENC J2K and
ENC 10bit 4:2:2 H264. Range for this value can be from 16 to 8190.
PID Configuration:
This parameter sets the method to configure the PID. If it is pre-defined, then all
PID controls will be greyed out. The second method allows the user to manually configure them.
Program Tuning Mode:
This parameter allows the user to select the Program Tuning Mode for the
decoder.
•
Auto PID Select:
automatically choose the PIDs for each audio stream, based on Auto
Program Sel Mode.
•
Manual PID Select:
manually select PIDs for each audio stream.
Auto Program Sel Mode:
This parameter allows the user to set how the decoder will select a program
for decoding, when programTuningMode is set to auto.
•
First Program In PAT:
select audio PIDs from the first program will be chosen.
•
Lowest Program Num:
select audio PIDs from the lowest program will be used.
•
Specific Program Select:
will pick audio PIDs from specific program, specified by Program
Number Select control for decoding.
Содержание 3067VIP10G Series
Страница 2: ...This page left intentionally blank ...
