evertz 3067VIP10G Series, Руководство пользователя

Страница: 12 / 46

3067VIP10G Series User Manual
JPEG2000 Advanced Compact Multi-Image Display Processors
Page 4
Revision 0.1
provided. Locate on the rear of the rack the two slots and remove the blanking panels. Insert the rear
panel into the back of the chassis and secure using the screws provided.
Now insert the 3067VIP10G card into the corresponding front slots ensuring the card lines up with the
slot runners on the bottom and the top of the chassis. Push the card
firmly into the slot ensuring that
when it mates with the rear card it has been firmly pushed into a seated position. Do not connect any
cables to the rear card (failure to do this could cause unwanted network issues) until the initial
configuration has been completed.
Ensure that the device is powered up and the green LED is on. Connect the device via the COM port
using a 9-pin d-type ribbon serial cable, connect the end of the serial cable to the serial port of your PC.
Connect the opposing end to the upgrade port J1 labeled on card. This port is located directly behind
card edge LED panel. In order to begin configurations ensure the below settings are configured
properly:
Baud: 115200
Data: 8-BIT
Parity: none
Stop Bits: 2
Flow Control: none
Open TeraTerm (if using Windows XP or older open Hyper Terminal) to make the required changes to
the IP address on the card. Use the login
customer and password customer.
2.3. CONFIGURING BASIC NETWORK SETTINGS
To make changes to the IP address select Network Setup . Set the IP address to the desired subnet as
well as set the Gateway . Make the same changes for the IP address and Gateway of Port 2 as
required. When done Exit (X) the Network Setup and Save and Exit (X) from the Main Menu to ensure
all changes are saved.
Power Cycle the 3067VIP10G to ensure all changes are loaded to the card.