8
9
Model number JUS750CE
Contact us / 1-877-571-2391
Model number JUS750CE
Contact us / 1-877-571-2391
USB PORTS
The USB Power Button and the two USB Ports are located on the front of the unit. The
USB Ports provide a total of 2.1A (5V each).
When the USB Ports are in use, the unit will monitor for the following USB fault
conditions on both USB Ports: low battery voltage fault, overload and short circuit. If a
fault condition exists in either of the USB Ports, the backlit LCD screen will continuously
display the following:
The Fault Icon will flash. The USB Ports will automatically shut down. Should this occur,
disconnect the USB-powered device and press the USB Power Button again to turn off
the USB Ports immediately. Make sure the unit does not need to be recharged. Allow
the unit to cool down for several minutes before attempting to use the USB Ports again.
If a fault occurs again, make sure that the total draw the USB devices plugged into
the USB Ports does not exceed 2.1A (5V each). If an individual USB device is within
specifications and the fault occurs, have the USB device checked for malfunction and
do not continue to use it with these USB Ports.
USING THE USB PORTS
1. Press the USB Power Button to turn on both USB Ports. A beep will sound, the
backlight will turn on for 10 seconds (only) and the LCD screen will continuously
display the following:
The Battery Status Icon and Battery Voltage Indicator will light solid, as well as the
USB Icon, indicating the USB ports are ready to use.
2. Plug the USB-powered device into the USB power port(s) and operate normally.
3. Press the USB power button again to turn off the USB Ports.
Periodically check the unit’s battery status on the backlit LCD screen. Four solid bars in
the battery icon indicates a full battery. When the battery level is nearly empty with only
one solid bar or completely empty with 4 empty bars, the unit must be recharged at this
time or the unit’s built-in low voltage protection will activate. The empty Battery Status
Icon will flash for a short period of time before automatic shut down.
IMPORTANT:
Make sure the USB Ports are turned off when the unit is being recharged
or stored.
Notes:
This unit’s USB Ports do not support data communication. They only provide power to external USB-
powered devices. The two USB Ports provide a total of 2.1A (5V each).
Some household USB-powered electronics will not operate with this unit.
PORTABLE COMPRESSOR
The built-in 12 volt DC compressor is the ultimate compressor for all vehicle tires, trailer
tires and recreational inflatables. A nozzle adaptor is supplied that screws onto the end
of the Sure Fit
®
nozzle at the free end of the compressor hose. The compressor hose
with tire fitting is stored in the compressor hose storage compartment. Refer to the
“Features” illustration for locations of compressor hose. The Compressor Power Button
and Increase (+) and Decrease (–) Compressor Pressure Control Buttons are located on
the control panel on the front of the unit.
Before proceeding, check the unit’s battery status on the LCD screen. Four solid bars in
the battery icon indicates a full battery. When the battery level is nearly empty with only
one solid bar, the unit MUST be recharged before use or the unit’s built-in low voltage
protection will activate. The empty Battery Status Icon will flash for a short period of
time before automatic shut down.
The compressor is capable of inflating up to 120 pounds per square inch (psi) pressure.
The compressor can operate long enough to fill up to 3 average sized tires before the
battery must be recharged. Return hose to the storage compartment after use.
IMPORTANT:
Make sure the Jump Starter Power Button has been turned off before
attempting to use the unit as a Compressor.
WARNING –
To reduce the risk of serious injury or property damage:
Follow all safety
instructions found in the “Specific Safety Instructions for Compressors” section of this
instruction manual.
CAUTION –
To reduce the risk of serious injury or property damage:
When the
compressor is operated at a low PSI, the unit may start in low and gradually rev up.
When the compressor is operated at higher PSIs, the unit may operate normally for
several minutes, then rev down for a few minutes before returning to normal operation.
This feature protects the unit from overheating during normal use. In any event, do not
operate compressor continuously for longer than 10 minutes, as it may overheat. This
could damage the compressor. If the compressor must be operated for longer periods:
every 10 minutes press the Compressor Power Button to turn the compressor off, then
restart after a cooling down period of approximately 30 minutes.
Inflating Tires or Products With Valve Stems
1. Screw the Sure Fit
®
nozzle onto the valve stem. Do not overtighten.
2. Press the Compressor Power Button. A beep will sound and the backlit LCD
screen will display the following:
The Compressor Icon will light and the digital display will alternately show the
flashing pre-set psi value (that was last set by the compressor pressure control
buttons) and the current pressure of the item being inflated (which will light solid).
3. Press the “+” and “–” Pressure Control Buttons to set the desired pressure from
a range pre-set values (between 3 and 120), which will display on the backlit LCD
screen. The unit will sound a beep with each press of the buttons (holding the
button speeds up the upward or downward value selection). Once the desired
pressure has been entered, release the button and the flashing digital display will
show the new selected pressure, as follows:
The new selected value is now stored in the unit’s memory until it is manually reset.
4. Press the Compressor Power Button once more to begin inflating. The
Compressor Icon will flash and the digital display will only show the current
pressure value (which will light solid) to indicate the compressor is activated.
Monitor the pressure on the LCD screen.
IMPORTANT NOTE:
To interrupt during inflation, press the Compressor Power
Button again.
5. When desired pre-set pressure is reached, the compressor will automatically stop.
6. Press the Compressor Power Button again to turn off the unit.
7. Unscrew and remove the Sure Fit
®
nozzle from the valve stem.
8. Allow the unit to cool, then recharge before storing away.
9. Store the compressor hose and Sure Fit
®
nozzle in storage compartment.
Inflating Other Inflatables Without Valve Stems
Inflation of other items requires use of the nozzle adapter.
1. Screw the nozzle adapter into the Sure Fit
®
nozzle. Do not overtighten.
2. Insert the nozzle adapter into item to be inflated.
3. Follow steps 2 through 4 of the “Inflating Tires or Products With Valve
Stems” section.
IMPORTANT:
Small items such as volleyballs, footballs, etc. inflate very rapidly.
Keep this in mind when setting pressure. Take extra care not to over-inflate.
4. When the desired pressure is reached, the compressor will automatically stop.
Press the Compressor Power Button again to turn off the unit.
5. Disconnect the adapter from the inflated item.
6. Unscrew and remove the nozzle adapter from the Sure Fit
®
nozzle.
7. Allow the unit to cool, then recharge before storing away.
8. Store the compressor hose, Sure Fit
®
nozzle and nozzle adapter in the storage
compartment when not in use.
CARE AND MAINTENANCE
All batteries lose energy from self-discharge over time and more rapidly at higher
temperatures. When the unit is not in use, we recommend that the battery is charged at
least every 30 days.
From time to time wipe the outside of the appliance with a soft cloth. Do not immerse
the appliance in water.
There are no user-replaceable parts. Periodically inspect the condition of adapters,
connectors and wires. Contact manufacturer to replace any components that have
become worn or broken.
Battery replacement/disposal
BATTERY REPLACEMENT
The battery should last the service life of the unit. Service life is dependent on a number
of factors including but not limited to the number of recharge cycles, and proper
care and maintenance of the battery by the end user. Contact manufacturer for any
information you may need.
SAFE BATTERY DISPOSAL
Contains a maintenance-free, sealed, non-spillable, lead acid battery,
which must be disposed of properly. Recycling is required. Failure to
comply with local, state and federal regulations can result in fines,
or imprisonment.
Please recycle.
WARNINGS:
• Do not dispose of the battery in fire as this may result in an explosion.
• Before disposing of the battery, protect exposed terminals with heavy-duty electrical
tape to prevent shorting (shorting can result in injury or fire).
• Do not expose battery to fire or intense heat as it may explode.
TROUBLESHOOTING
Problem
Possible Solution
Unit will not charge
• Make sure all of the unit’s functions are turned off.
• Make sure a suitable gauge extension cord is properly
connected to both the unit and a functioning AC outlet.
Unit fails to jump-
start
• Make sure the unit is not being operated in the
Compressor mode.
• Make sure unit’s jump-starter power switch is in the on
position.
• Make sure a proper polarity cable connection has been
established.
• Check that unit has a full charge. Recharge unit if necessary.
Problem
Possible Solution
USB power port will
not power appliance
• If a fault condition exists in either of the USB Ports, the
Fault Icon on the LCD screen will flash. Refer to the
Important Notes in the
“
USB Ports
”
section to remedy
any faults.
• Make sure that the total draw of all USB devices plugged
into the USB Ports does not exceed 2.1A.
• Some USB-powered household electronics will not operate
with this USB charging/power port. Check the manual of
the corresponding electronic device to confirm that it can
be used with this type of USB charging/power port.
• Make sure the USB power button has been pressed to turn
the USB ports on.
• Check that unit has a full charge. Recharge unit if necessary.
LED area light does
not come on
• Make sure the area light power button has been pressed to
turn the area light on.
• Check that unit has a full charge. Recharge unit if necessary.
Portable compressor
will not inflate
• Make sure the unit is not being operated in the Jump
Starter mode.
• Make sure the compressor power button has been pressed
to turn the compressor on.
• Make sure the Sure Fit
®
nozzle connector is securely
screwed on to the valve stem when attempting to inflate
tires; or that the nozzle adapter is securely screwed into
the Sure Fit
®
nozzle connector and is inserted properly into
the item to be inflated on all other inflatables.
• The compressor may be overheated. Press the compressor
power button to turn the compressor off. Restart after a
cooling down period of approximately 30 minutes.
• Check that unit has a full charge. Recharge unit if necessary.
ACCESSORIES
Recommended accessories for use with your tool may be available from the
manufacturer. If you need assistance regarding accessories, please contact the
manufacturer at (877) 571-2391.
WARNING:
The use of any accessory not recommended for use with this appliance
could be hazardous.
SERVICE INFORMATION
Whether you need technical advice, repair, or genuine factory replacement parts,
contact the manufacturer at (877) 571-2391.
ONE-YEAR LIMITED
WARRANTY
The manufacturer warrants this product against defects in materials and workmanship
for a period of ONE (1) YEAR from the date of retail purchase by the original end-user
purchaser (“Warranty Period”).
If there is a defect and a valid claim is received within the Warranty Period, the defective
product can be replaced or repaired in the following ways: (1) Return the product to
the manufacturer for repair or replacement at manufacturer’s option. Proof of purchase
may be required by manufacturer. (2) Return the product to the retailer where product
was purchased for an exchange (provided that the store is a participating retailer).
Returns to retailer should be made within the time period of the retailer’s return policy
for exchanges only (usually 30 to 90 days after the sale). Proof of purchase may be
required. Please check with the retailer for their specific return policy regarding returns
that are beyond the time set for exchanges.
This warranty does not apply to accessories, bulbs, fuses and batteries; defects
resulting from normal wear and tear, accidents; damages sustained during shipping;
JUS750CE_Manual_ENSP_042820.indd 8-9
JUS750CE_Manual_ENSP_042820.indd 8-9
4/29/2020 2:16:37 PM
4/29/2020 2:16:37 PM
