- 6 -
e. Please carefully select the installation position of your device, as to make
sure the GSM has good signal. Please see Test Mode Point 4.
f. The SIM card must not be expired.
g. The “Show Caller ID” function must be enabled on the mobile phones for
the host phone number and SMS phone number for the host to determine if
the phone number is authorized to use the SMS function.
4-1 Alarm Message Play Function
4-1-1 Alarm Message Play Time:
maximum cycle length is 30 seconds.
4-1-2 Record Alarm Message:
the Help message can be recorded; Alarm
message up to 10 seconds, and will be played every time when a
condition is triggered.
4-1-3 Replay Alarm Message:
hold the Record button to play the Alarm
message.
4-1-4 Confirm Telephone Times:
the default is 3 times. Pressing the “
*
”
button on a remote phone will enter the remote control procedure. Press
8 again to confirm and the confirmed call will be temporarily canceled.
When confirmed times have been reached all phone calls will be
canceled.
4-1-5 Call Attempts:
the default is 3 times. All attempted calls will count as 1
times before the Confirm Times has been reached. The call will stop
when the maximum call value has been reached.
4-2 Special Functions
4-2-1 Warning SMS Notice and Host Parameter Setup
When the host generates an alarm, an SMS will be sent first from the
preset SMS phone number to notify the user on the condition.
4-2-2 Alarm Voice Automatic Call
When the host generates an alarm, the preset voice telephone number
and help message will automatically call and notify the user of an alarm
condition. Please refer to the Trigger Call Procedures.
4-2-3 System Disarm Notification
When the RFID Tag is on the Host tag sensor, an SMS will be sent to the
Host Phone Number if Fully Arm is set to Disarm and notify the user on
who disarmed the system.
4-3 Built-In Automatic Voice Dial
4-3-1 How to enter Reverse Control:
The user may press “
*
” when hearing the USC423A alarm call. The alarm
will stop and the device will enter “Reverse Control” mode and wait for
function input. Press the “#” or wait 30 seconds to end the call (Listen In
or Two Way Talk excluded).
4-2-2 Reverse Control Procedures:
a.
Press “
*
” and input Key (0 – 9 and *) after the message to enter Remote
Control Procedures. Timeout will occur if no Keys were input after 30
seconds.
b.
When Key = 1 (Full Arm and send SMS)
c.
When Key = 2 (Part-Arm and send SMS)
d.
When Key = 3 (Set the Siren to turn on Alarm and send SMS)
e.
When Key = 4 (Set the Siren to turn off Alarm and send SMS)
f.
When Key = 6 (Listen to the Alarm message again)
g.
When Key = 7 (Enter Listen In Mode. Timeout will occur after 5 minutes)
h.
When Key = 8 (Cancel telephone notice and send SMS)
i.
When Key = 9 (Enter Two Way Talk Mode. Timeout will occur after 5
minutes)
j.
When Key = 0 (Disarm and send SMS)
4-2-3 Trigger Call Procedures
When an event triggers, the device will call the preset number and play
the alarm message for 30 seconds. Pressing a Key will enter Remote
Control. The call will end after 30 seconds and contact the next set of
numbers and repeat the steps.
4-2-4 SMS Functions
Setup
SMS Sent
Operation
SMS in Return
Operation
Menu 1
#
0 Disarm
1 Arm
2 Partial Arm
3 Two-way Talk
4 Listen In
00 System Status
? Phone Number Setup
