background image

installation.  This equipment generates, uses and can radiate radio frequency 
energy and, if not installed and used in accordance with the instructions, may cause 
harmful interference to radio communications.  However, there is no guarantee 
that interference will not occur in a particular installation.    If this equipment does 
cause harmful interference to radio or television reception, which can be determined 
by turning the equipment off and on, the user is encouraged to try to correct the 
interference by one of the following measures: 

Reorient or relocate the receiving antenna. 

Increase the separation between the equipment and receiver. 

Connect the equipment into an outlet on a circuit different from that to which the 
receiver is connected. 

Consult the dealer or an experienced radio/TV technician for help. 

 
This device complies with Part 15 of the FCC Rules. Operation is subject to the 
following two conditions: (1) This device may not cause harmful interference, and (2) 
this device must accept any interference received, including interference that may 
cause undesired operation. 

 

FCC Caution: Any changes or modifications not expressly approved by the party 
responsible for compliance could void the user's authority to operate this 
equipment. 
 
This transmitter must not be co-located or operating in conjunction with any other 
antenna or transmitter.

 

 

WARNING: 

Do not dispose of electrical appliances as unsorted municipal waste, use separate 
collection facilities.   
 
Contact your local government for information regarding the collection systems 
available. 
 
If electrical appliances are disposed of in landfills or dumps, hazardous substances 
can leak into the groundwater and get into the food chain, damaging your health 
and well-being. 
 
When replacing old appliances with new once, the retailer is legally obligated to take 
back your old appliance for disposal at least for free of charge. 
 

Содержание SP103

Страница 1: ...he tamper switch on the detector to complete the inclusion exclusion process FIGURE 1 Choosing A Mounting Location The recommended position for a PIR Detector is in the corner of a room mounted 2m from the floor At this height the detector will detect movement up to 6 12m depending on adjustment FIGURE 2a Also in this position the 110 degrees fan shaped detection pattern can normally offer greater...

Страница 2: ...he Detector will turn OFF the load or the lamp plugged into the On Off Module AN135 Lamp Module AD130 The red indicator LED on the load or the connected lamp will be off too 2 When the tamper switch is pressed the unit will enter normal mode Upon motion being sensed the Detector will turn ON the load or the lamp plugged into the On Off Module AN135 Lamp Module AD130 After the elapse of preset time...

Страница 3: ...is one minute For instance please always enter 60 120 or 180 seconds etc all of which are equivalent to 1 2 and 3 minutes respectively The time interval of wakeup cannot be entered 59 61 119 121 179 or 181 seconds Troubleshooting Symptom Possible Cause Recommendation Cannot carry out inclusion and association 1 Run out of battery power 2 Check if reverse battery polarity 3 Check if the detector is...

Страница 4: ...t 15 of the FCC Rules Operation is subject to the following two conditions 1 This device may not cause harmful interference and 2 this device must accept any interference received including interference that may cause undesired operation FCC Caution Any changes or modifications not expressly approved by the party responsible for compliance could void the user s authority to operate this equipment ...

Отзывы: