13
NOTES:
1)
Do not attempt to use the foot pedal to control the amps.
2)
Do not flip the process switch while cutting or unit failure may result.
3)
Attempt to cut only when air pressure is beins supplied. Always check gauge to confirm air pressure is present before cut
4)
Do not exceed 85 psi air supply pressure from the compressor or failure of components may result.
5)
Adjust torch operation pressure to 55
-
65 psi for best results while post flow is flowing. (Increase post flow time to maxi-
mum to allow enough time to set pressure.)
6)
When using the lower amp range, the nozzles will need to be changed out for ones with a smaller diameter orifice. Ever-
last is the OEM supplier of the torch but not the manufacturer. Low amp cuts may be unstable unless the size is matched
to the amps being used. Although the unit can be adjusted as low as 10 amps, this does not guarantee stable cutting at
this amperage. Minimum suggested cutting amps is 25
-
30 amps for the AG 60 torch with the smallest available consuma-
ble. Other torches with smaller consumables may be fitted to supply better low end cutting capability.
7)
Do not use the pilot arc continuously. It is designed for momentary use. Do not fire the torch unless ready to cut or ad-
just the cutting pressure. Excessive use creates point gap wear, and can also damage surrounding electronics.
ALWAYS
CUT WITH THE WORK CLAMP ATTACHED.
8)
If the pilot arc does not transfer and only a shallow cut or gouge is noticed, check the work clamp to make sure it is
attached directly to clean rust free area of the work piece and that the cable is secure to both the torch and work clamp.
Make sure that the cables are located securely in the connectors.
WORK (+)
QUICK SETUP AND USE GUIDE
Section 2
QUICK SETUP GUIDE: PLASMA CONNECTIONS
PILOT
AG-60
GAS
CONTROL
PILOT ARC
AIR
SWITCH
Содержание superultra series
Страница 34: ...34...
