Everglades 2012 275 CC, Руководство пользователя

Страница: 100 / 148

100
Exterior Equipment
To use the seats, swing the bolster up, then pull
the top of the seat toward the cockpit. The bottom
of the seat slides in a track and two side supports
move out with the seat as it folds out. The seat
automatically locks into the seating position when
the cushion reaches the full down position.
To store the seat, pull the seat out slightly as you
raise the front of the seat. The rear supports will
release and slide down in the track as the seat
and side supports fold into the recess. Swing the
bolster up and fold the seat in until it is flush with
the recess. Lower the bolster to secure the seat
in the folded position.
Systems Compartment Access
A hatch in the rear of the cockpit provides access
to the batteries, battery switches, pumps, strain-
ers, circuit breakers and other equipment in the
systems compartment. The stern bilge pumps,
raw water supply manifold, baitwell supply pump,
fresh water and raw water pumps, fuse panels
and battery charger are among the equipment in
this compartment. The hatch is held open by a
gas spring and secured with two rotating latches
when it is closed. There is a large red dot in the
latch handle that indicates that the latch is in the
open position and the hatch is not secure. Always
make sure the hatch is closed with the latches in
the secured position before operating the boat
above idle speed.
Bait Station
A bait prep station equipped with a sink, cutting
board and tackle storage is on the rear of the helm
seat base. The sink is plumbed to the fresh and
raw water systems and has a removable spray
head that reaches to each side of the station or
can be used as a fresh/raw water washdown or
shower. The sink is drained by gravity to a thru-
hull fitting in the hull side. Grab rails, cup hold -
ers, accommodation for hooks, knives and tools
are built into the top of the station. There are
two large tackle drawers with removable trays
and other drawers for additional storage. A door
in the center of the station provides storage for
large items and access to the fuel line fittings
and fuel gauge sender located below the round
access hatch. The “push to close” latches secure
the storage door and each drawer when they are
closed. They latch automatically and are lockable.
A 94 quart cooler is mounted in a special compart-
ment at the front of the seat base below the helm
seats. The cooler is secured with a door that is
hinged at the bottom and secured with two spring
325 Center Console
Aft Bench Seats with Bolster Down
325 Center Console
Systems Compartment Access Hatch
325 Center Console
Bait Station
actuated latches. To slide the cooler out of the
compartment, release the two latches and rotate
the door down until it lays flat on the cockpit sole.
Then slide the cooler out. Make sure the cooler
is slid completely into the compartment with the