13
BRIGHTNESS
Scroll to this field and then scroll left or right to increase or decrease the screen brightness level
(0 to 100).
ETR ( EverFocus Tone Reproduction)
ETR
is an advanced form of electronic wide dynamic range expansion used to deliver properly
exposed images despite bright light sources, deep shadows and/or unbalanced lighting in the
same scene . Choose from OFF, LOW ~ HIGH.
EFECT (EverFocus Enhanced Contrast Technology)
EFECT analyzes the distribution of luminance across the image and processes the signal to
improve contrast and increase image clarity, by reducing effects
due to dispersion of light
caused by fog, smoke and similar conditions. Choose from OFF, LOW ~ HIGH.
BACKLIGHT
•
OFF
•
BLC
(Backlight Compensation):
GAIN – Select LOW ~ HIGH. Video gain is adjusted automatically to correct the
exposure of subjects that are in front of a bright light source. In the AREA setting below, you
can select the area on the image that this BLC Gain level will apply to.
AREA – Press Enter to enter the AREA setup screen’s Position mode. Use the direction
buttons to position the area selector block’s left and top borders. Press Enter again to
activate the Size mode and use the direction buttons to select the area selector block’s right
and bottom borders. Press Enter again to see a flashing RET and non-flashing AGAIN sign.
Press Enter to return to the previous screen, or scroll right to see a non-flashing RET and a
flashing AGAIN sign. Press Enter if you want to change the position of the area selector
block, or scroll back to RET and press Enter to return to the previous screen (BLC). The BLC
Gain setting above will apply to this area only.
DEFAULT – Press Enter in this field to return the area selector block to its default
position and size.
•
HSBLC
(Highlight Suppression BLC):
SELECT – Scroll sideways to select the HSBLC area selector block you want to edit. The
block associated with the selected area number will start flashing when you select it. All
changes in the DISPLAY field below will apply to this block only. The HSBLC Level setting
(below) will only apply to the blocks that have been activated.
DISPLAY – Select OFF to hide the selected area indicator block. Select ON to display the
block and activate its block-positioning submenu. In ON mode, press Enter to enter the
submenu and use the direction buttons to select the top and right position of the area
block. Press Enter again to activate the Size mode and use the direction buttons to select
the bottom and left borders of the area selector block. Press Enter again to see a flashing
RET and non-flashing AGAIN sign. Press Enter to return to the previous screen, or scroll
