ELUX4 / ELUX8 / ELUX16 Full HD Hybrid DVR
12
3.1
Monitor Connection
Connect the monitor to the HDMI, VGA or BNC port on the rear panel of the DVR. The DVRs
provide 2 main monitor outputs (HDMI and VGA) and 1 call monitor output (BNC).
The main monitor output can deliver full HD output resolution (1920x1080, progressive, 60 Hz.
vert., 68 KHz hor.). The call monitor can display camera streams or perform sequence display
mode. Make sure that the connected monitor's specifications comply with the resolution
requirements. To configure the monitor setting, please refer to 6.6 Display Setting in the User’s
Manual.
The 2 main monitor outputs provide the identical functionality. Both of the main monitors can be
operated simultaneously. Both of the call monitors can be operated simultaneously.
The DVRs support 4 (4CH DVR) / 8 (8CH DVR) / 16 (16CH DVR) looping outputs. You can optionally
use the Loopout Cable (see 1.5 Optional Accessories) to loop out each video channel. Connect one
end of the Loopout Cable to the LOOPOUT port on the rear panel of the DVR and the other ends
(BNC ports) to the monitors. For 4CH / 8CH DVR, one Loopout Cable is required (with 4 / 8 BNC
ports); for 16CH DVR, two Loopout Cables are required (with 1-8 and 9-16 BNC ports).
Note that
the videos will not be looped out when DVR power is turned off.
The figure below uses ELUX4 as an example.
Main Monitor
Call Monitor
Main Monitor
BNC Cable
VGA Cable
HDMI Cable
Loopout Cable
Video Looping
Output 1~4 (BNC)
Note:
1.
The connected monitors’ specifications must comply with the resolution requirements.
2.
Do not exceed the max. HDMI cable length of 15 meters. The standard HDMI cables can
support cable length up to 3 meters. For longer distances, such as 15 meters, it is highly
recommended to use high quality HDMI cables.