EverFocus EFC302, Руководство пользователя, Страница: 64 / 160

NAV IP Access controller
55
Panic Open alarms are designed to allow users who are forced to enter a building under duress to
silently trigger an alarm. When the door’s access schedule is configured as PIN needed, for example:
“Card or PIN” or “Card plus PIN”, cardholders can type in their panic PIN to trigger a panic open event in
the system.
The panic PIN is the cardholder’s original PIN plus any two digits. For example, Sam’s PIN is 12345678.
He can type in any two more digits following“12345678” as the panic PIN, such as “1234567800”.The
time setting for panic open event is shown in the below figure:
Press numeric keys to input the specified alarm time for the event. Press to confirm and press
to discard the change just made.
5.6.4.21 Event Alarm Action Setting
Press at the below screen to configure event alarm action setting.
The event alarm action defines which alarm output can be triggered by the event. As we explained
before, NAV Controller can take main modules, up to 4 door modules and 1 alarm module, total 18
alarm output. Users will be able to configure the event to trigger any one or multiple outputs from those
18 alarm outputs.
The event alarm action setting includes three submenus, shown in below.
The alarm output setting on these three screens are the similar. For example, the fire alarm event
actions on door module will look like:
The top line indicates the event to be configured. The bottom line is the setting of alarm outputs on 4
door modules. Y indicates there is alarm output (relay energized) and N indicates there is no alarm
output (relay not energized). R refers specifically to alarm output on the door module, indicating that
alarm output will be generated only if the event occurs on the corresponding door. The above example
means the alarm output relay at door 1 will be energized if door forced open event happens on any door,
the alarm output relay at door 2 does not respond to any door forced open event, and same as door 4 to
8. Door 3 indicates the alarm output relay on door 3 will be energized if and only if the door 3 got a
forced open event.
Note “R” option for alarm output does not apply to alarm module and main module, since they don’t
naturally correspond to a door control.
In the above menu, press numeric key 1~8 to toggle the alarm output actions of this event on the door
module among Y, N, and R (only for door module). Press and to navigate to other alarm
action settings.
Door Forced Open
YNRNNNN
Event Alarm action
on Alarm Module
Event Alarm action
on Door Module
Event Alarm action
on Main Module
EventAlarm action
Setting
Panic Open
000Min 10Sec