Value IP 2MP 288 Series / 3MP 368 Series
10
Reset Button
1.
Reboot the camera:
When the camera is powered up, press the
Reset Button
will reboot the camera.
2.
Restore the camera:
Keep the
Reset Button
pressed, at the same time unplug the camera power then plug it back again
will return camera settings to the factory default values.
4.4.
Basic Installation
4.4.1.
Mounting and Wiring
EBN288/368
1.
Before screwing the camera to the wall, stick the
Sticker
on the wall / ceiling to mark the position
for installation. Drill four holes on the wall / ceiling according to the supplied
Sticker
and push the
supplied four
Screw Anchors
into the four holes on the wall / ceiling. Drill another hole in the
middle of the
Sticker
if you wish to run the wires into the wall / ceiling.
2.
Twist the Outer Housing counterclockwise and then remove the Outer Housing from the camera
base.
3.
Place the camera base on the wall / ceiling and run the cable through the camera base first.
