Value IP 288 / 368 / 468 Series
19
EZN288/368/468
&
EZN288M/368M/468M
1.
Before screwing the camera to the wall, stick the
Sticker
on the wall / ceiling to mark the screw
position. Drill three (
EZN288/368/468
) or four (
EZN288M/368M/468M
) holes on the wall / ceiling
according to the supplied
Sticker
and push the supplied
Anchors
into the holes on the wall / ceiling.
Drill another hole in the middle of the
Sticker
if you wish to run the wires into the wall / ceiling.
EZN288/368/468
EZN288M/368M/468M
2.
You can wire the cables from the side of the camera or through the wall.
Wire the cables from the side of the camera
Wire the cables through the wall
3.
Place the camera’s base against the anchoring surface so that the holes line up. Screw the camera
to the wall / ceiling using the supplied
Screws
.
4.
Optionally insert a micro SD / SDHC / SDXC card into the card slot. Please refer to
4.4.2 Inserting a
micro SD Card
.
5.
Connect the LAN / PoE cable to the camera.
a.
Remove the
Screw Cap
from the
Cable Glan
d
.
b.
Insert a RJ-45 network ca
ble (without the RJ-45 connector on the one end) through the
Cable
Gland
and
Screw Cap
.
