12
WWW.EVERETIMAGING.COM
SETTING 1-4 CAMERAS
The SET keys are used to connect one of the
CAM buttons to a specific camera. For
example. If you have a EVP212, EVP220 and
EVP230 and you want to configure them as
follow:
CAM1 = EVP212
CAM2 = EVP220
CAM 3 =EVP230
1.
Point the IR to camera you would like
to configure.
2.
Long press one of the SET1 button for
3 seconds until the key light of one of
the CAM buttons starts flickering red.
3.
When the happens just let go of the
SET button you were pressing.
4.
Short press CAM1 button to configure
for e.g. EVP212 to CAM1.
Every time you press CAM1 you will be
controlling the EVP212. You can follow these
exact steps to configure other cameras.
NOTE: If you want to configure more cameras
to the same CAM number than you should SET
all the cameras to CAM1.
PRESET NUMBER KEY (1-9)
Set preset: long press (3 seconds) the number
key to set preset.
Call preset: Short press the number key to run
preset.
CLR PRE (CLEAR PRESET)
Press CLR PRE and then choose number key of
the preset you like to clear.
Long press CLR PRE to clear all presets.
FOCUS KEY ( ON THE LEFT)
With this button the focus of the camera can
be controlled when it is in Manual focus mode.
ZOOM KEY( ON THE RIGHT SIDE)
= Zoom in
= Zoom out
NAVIGATE KEY: UP/DOWN/LEFT/RIGHT
Under working mode, use navigate key to set
the pan tilt, and select menu when enter OSD.
OK
Under working mode, short press OK to make
the camera go back to Default PTZ position;
and confirm the selection when enter OSD.
AF: Auto Focus
MF: Manual Focus
RESET: Press 3 seconds to reset camera
MENU: Enter OSD menu
LEARN+LIMIT L key:
Set the pan tilt left limit position.
LEARN+LIMIT R key:
Set the pan tilt right limit position.
LEARN+LMT CLR key:
Clear the limit position.
BLC OFF/ BLC ON:
Set backlight ON/OFF
BRIGHT-/:
Set image brightness, only valid under bright
priority exposure mode.
