3
7. WARNING
-Do not use electrical appliances inside the food storage compartments of the appliance unless they are of
the type recommended by the manufacturer.
8.Power source disconnected your refrigerator before carrying out user maintenance on it.
9.
If a component part is damaged, it must be replaced by the manufacturer, its service agent, or similar qualified persons
in order to avoid a hazard.
10.
Follow local regulations regarding disposal of your refrigerator due to flammable refrigerant and gas. All refrigeration
products contain refrigerants, which under the guidelines of federal law must be removed before disposal. It is the
consumer's responsibility to comply with federal and local regulations when disposing of this product.
11.
Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
12. This appliance is intended to be used in the recreational vehicle.
1
3.
This appliance is intended to be used in recreational vehicle.
P
OWER SOURCE REQUIREMENT
This appliance is Class III appliances, it must only be supplied at safety extra low voltage.
It should have a circuit breaker for full disconnection from the appliance and power supply mains.
Before using, the appliance should be disconnected from main power supply, and conduct wiring connections by
reference to the wiring diagram.
Do not connect the unit to AC power supply.
1.
In order for normal use, the connection must be reliable. Besides the power source roper connection, the wire of the
unit and outer wire must meet the following requirement:
Wire size
The max length (Feet)
14 AWG
3.2 Feet
13 AWG
8 Feet
12 AWG
13 Feet
10 AWG
20 Feet
8 AWG
33 Feet
6 AWG
50 Feet
Remarks
14 AWG wire is not recommended. 13 AWG wire or larger is recommended.
This DC unit is not equipment with a power source. Please purchase a power
source from an authorized dealer.
2.
When using an adaptor or converter AC to DC, No DC power supply is recommended.
3.
It is recommended that only authorized or qualified professionals perform repair services on unit.
W
IRE CONNECTION DIAGRAM
1. Connect
①
terminal with Positive pole of 12V DC.
2. Connect
②
terminal with Negative pole of 12V DC.
3. If the unit is installed in an RV, the
③
GND terminal should be connected directly to the RV chassis..
