DIR911 Instant Recall Recorder
©2000 Eventide Inc.
12
TEST/ADJUST OFF HOOK ACTIVATION Screen
-
Test/adjust the off hook record
level
First, make sure that the phone is on the hook and the display reads “ON HOOK.” If it
does not, adjust the trim pot labeled “Off Hook Adjust” (on the back of the unit) until the
display reads “ON HOOK.” When you lift the phone off the hook, the display should say
“OFF HOOK.” If it does not, adjust the same trim pot until the display reads “OFF
HOOK.” You may need to lift the phone on and off the hook a few times to check this
setting.
VOX RECORD ACTIVATION Screen
-
Leads to Test/adjust of VOX record level and
hold time
This screen leads to screens that allow you to edit the VOX record level and hold time
for both the telephone and auxiliary channels.
TEST/ADJUST VOX RECORD ACTIVATION Screen
-
Test/adjust the VOX record
level
You will need access to the phone or auxiliary input device used with the DIR911 for
proper VOX level adjustment. The VOX threshold level (in decibels) is the level that the
incoming signal needs to surpass to activate recording. Obviously, as the VOX level
number increases, the volume of the incoming signal needed to activate recording will
be higher. To test the setting, just talk into the phone or auxiliary input. At normal
volume levels, the RECORD message should read ENABLED. If not, then lower the
VOX level number until normal volume produces the message ENABLED.
If the setting is too sensitive (i.e., recording ENABLED when there is no signal), then
raise the threshold level until the message reads DISABLED.
The range of threshold settings is 0dB-42dB, with a default setting of 16dB on both
inputs.
The “CURSOR” key toggles between telephone and auxiliary adjustment. The
Adjustment on back of unit
sets on/off hook record level
Phone is currently: ON HOOK
DONE
Set VOX record level and hold time
LEVEL HOLD TIME DONE
Tele VOX lvl: +16 dB Record: DISABLED
Aux VOX lvl: +16 dB Record: DISABLED
Adjust here to set active record level
CURSOR DECREASE INCREASE DONE
