Page 5
Install lamphead by first locating in place in Backbox opening.
With pivoting door held open, insert Phillips screwdriver tip into center hole in Spring
Latch Bar, push down and forward to engage bar under two formed latch tabs in rear
of Backbox.
Transformer secondary cable must be trapped behind Latch Bar to prevent
interference with pivoting door.
Latch
Tabs
Push
door open
to access Spring Latch Bar
Spring Latch Bar
Insert Phillips screwdriver into hole
as shown, push down and forward
to engage latches.
NOTE:
Once Battery
is connected,
unit must be
energized
within 30 days.
Backbox
Spring
Latch
Bar
Battery
Connector
(2 Pin)
Transformer
Connector
(3 Pin)
Connect 2 pin Battery Cable first, then 3 pin Transformer Cable to matching
sockets on Printed Circuit Board.
BATTERY CABLE, WITH BATTERIES
CONNECTED, MUST BE ATTACHED BEFORE AC POWER IS APPLIED.
LAMPHEAD INSTALLATION