8
which is being used for any other appliance ,such as warmer tube, gas tube , hot wind
tube.
•The angle of the bend of the expansion pipe should not be less than 120º; you must
direct the pipe horizontally, or, alternatively, the pipe should go up from the initial point
and should be led to an outer wall.
•After the installation ,make sure that the cooker hood is level to avoid grease
collection at on end.
•Ensure the expansion pipe selected for installation complies with relevant standards
and is fire retardant.
WARNING:
➢
For safety reason, please use only the same size
of fixing or mounting screws which are
recommended in this instruction manual.
➢
Failure to install the screws or fixing device in
accordance with these instructions may result in
electrical hazards.
Start Using Your Cooker Hood
LED touch control
LED touch control has four buttons, see picture.
(Heat auto clean),
(Lamp),
(Speed),
(Power),
1. Power-on: After connecting the cooker hood to the main supply, the indicator light
of all buttons will turn on. The LED display
is closed .The cooker hood doesn’t work
and enter into stand-by mode.
2. (Power) button:
2.1 Press
(Power) button, the front cover of the cooker hood will be opened. The
indicator light of this button will be on and the hood will work at low speed, and
the light will be on. The indicator light of the buttons
(Speed) and
(Lamp)
