Evco EVF 300 Series, Руководство по установке

Страница: 35 / 62

EVCO S.p.A. EVF 300 series | Installer manual ver. 1.3 | Code 144F300E134
Page 35 of 62
Operate as follows to set a parameter:
8. Press and release the “TOP” key or the “FLOOR”
key: the top part of the “LOWER” display will show
the value of the parameter.
9. Press and release the UP or DOWN key within 15 s
to set the value of the parameter.
10. Press and release the “FLOOR” key or the “TOP”
key or do not operate for 15 s.
Operate as follows to exit the procedure:
11. Hold the “UP” key and the “DOWN” key down for 4
s or press and release the “ON/STAND-BY”; do not
operate for 60 s.
Cut the device power supply off after setting the
parameters.
14.6 Restoring the factory settings
Operate as follows to restore the factory settings:
1. Make sure there is no cooking cycle or any
procedure in progress.
2. Hold the UP and DOWN key for 4 s: the top part of
the “UPPER” display will show“ PA ”.
3. Press and release the “TOP” key or the “FLOOR”
key: the “LOWER” part of the display will show
“ 0 ”.
4. Press and release the “UP” key within 15 s to set
“ 149 ”.
5. Press and release the “TOP” key or the “FLOOR”
key or do not operate for 15 s.
6. Hold the UP and DOWN key for 4 s: the “UPPER”
part of the display will show“ dEF ”.
7. Press and release the “TOP” key or the “FLOOR”
key: the “LOWER” part of the display will show
“ 0 ”.
8. Press and release the “UP” key within 15 s to set
“ 1 ”.
9. Press and release the “TOP” key or the “FLOOR”
key or do not operate for 15 s: the top part of the
lower display will show flashing “ - - - “ for 4 s,
successively the top part of the upper display will
show flashing “ dEF ” for 4 s,after which, the device
will exit from the procedure.
10. Cut the device power supply off.
Setting the configuration parameters
Restoring the factory settings