EVBox Elvi, Инструкция по установке и эксплуатации, Страница: 25 / 38

Note:
When working on the station, place the station on a soft surface to protect it from damage. Be
careful not to damage the locking tabs on the station.
1. Remove the cardboard cover from the socket.
2. On the charging cable, make sure that the rubber seal is in place and not twisted. The rubber seal
must fit correctly to ensure that the enclosure rating is met.
3. Push the charging cable firmly into the station.
4. Turn the charging station over.
5. Install the Torx M6 x 45 bolt using the Torx T30 bit.
4.5. Install the station
See the corresponding illustrations in manual B.
No tools or materials are required to install the station.
Note:
The wall dock must be installed before the station can be installed.
Note:
When a wall dock cover has been installed, first remove the wall dock cover using the unlock
tools.
1. Align the station with the wall dock.
2. Press the station evenly onto the wall dock until you hear a 'CLICK'. Press on each corner of the
station to make sure that it is fully engaged with the wall dock.
Make sure that there is no gap between the station and the wall dock.
4.6. Commissioning
You can configure the operation of Elvi using the EVBox Connect app.
Charging stations can be connected to a Charging Management Platform (CMP) or they can be
configured as not-connected installations. Online charging stations connect to the CMP using Wi-Fi or
optional cellular data connection, depending on the model.
The charging station Chargepoint ID and Security code are required for configuration, and these are
located on the accessories folder.
4.6.1. Register the charging station with CMP (optional)
For an online charging station, activate the charging station with the CMP on the CMP website or by
using the CMP-specific app. Contact the Charging Point Operator (CPO) for details about the charging
station activation procedure.
4.6.2. EVBox Connect app
Download and install the EVBox Connect app on your smartphone or tablet:
4. Installation instructions
EN
21