www.evacuatoralarms.com
the Reset System logo on the right hand side of any of the Devices. The Status LED will then go Solid
Red, allow 90 seconds for the system to return into Standby mode.
Note: To perform the Test
without a Base Station you will require a Evacuator Secure Key Fob
Full Alarm
A full alarm can be raised from any Call Point in the system by lifting the hinged call point cover and
pressing the Push Button. This sounds the main beacon and flashes the strobe light on all Devices
connected to the system. The status LED will also Flash white. This will only stop when a reset
command is in place.
Resetting the System
If you are using the system without a Base Station you will need to purchase an Evacuator Secure
Key Fob. To put the system in to Reset swipe the fob over the Reset System Logo on the right hand
side of the product on any device in the system. The Status LED will then go Solid Red, allow 1
minute for the system to return to Standy mode.
Note: To perform System Reset without a Base
Station you will require a Evacuator Secure Key Fob
Final notes before use.
The Evacuator Synergy Category one Alert System has the flexibility to be utilised in a variety environments and is
suitable for a variety applications. However, It is the responsibility of the user/s to determine the application and
suitability of the products/s before use. Because we have no control over the systems use, installation or application,
FMC Fire, Evacuator Alarms its agents, distributors or employees accept no liability for loss or damages to property or
persons that may have been incurred by the use of this product.
We would therefore insist that a full risk assessment of the site and of the Synergy systems intended use is carried out
before installation of the system.
If you are not completely convinced or satisfied that this product will meet your safety or alert requirements then the
Synergy Wireless System should not be used and must be returned to your place of purchase immediately in its original
packaging.
E&OE.
Evacuator 3 Month Limited Warranty
This warranty is limited to the original purchaser and is not transferable. REPAIR OR REPLACEMENT
AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE PURCHASER.
This warranty covers only these products purchased from an authorized Evacuator dealer. Third
party transactions are not covered by this warranty. Proof of purchase is required for warranty
claims. Further, Evacuator alarms reserves the right to change or modify this warranty without
notice.