www.evacuatoralarms.com
Note: Each system must have one Master Device (00), to obtain maximum performance we
recommend the master is in the centre of the site. In order to identify the Device numbers we
recommend using the Device number box located on the side of the stickers.
Fitting the Antenna
The rubber duck antenna should now be fitted to the Silver BNC docking point located on the top of
the front cover. The Antenna should be placed over the BNC connector and twisted in clockwise
motion until it locates into place. Test that it has been located correctly by gently pulling on the
Antenna in an outwards motion.
Connecting the Battery and Fitting Front cover
The battery should be secured onto the back plate with the industrial Velcro supplied. Also be sure
that the black and red power leads are orientated to the right hand side of the moulding back plate
facing up. Now connect the white (male) two way plug from the battery into the white (female) plug
located on the inside of the front cover.
Once connected offer the front cover upto the wall mounted back plate making sure that the battery
lead does not foul on the central screw boss of the back plate. Once connected you will notice that
the LED on the front panel begins to flash.
When the front cover is located onto the back plate replace the M4 screw into the bottom of the
Siren Flasher/Strobe hole and locate it into the threaded insert in the back plate. This can now be
tightened down to pull the front cover flush to the back plate. DO NOT OVERTIGHTEN OR USE A
BATTERY OPERATED DRILL/SCREWDRIVER TO TIGHTEN THE SCREW AS THIS WILL RESUKT IN
PERMENANT DAMAGE TO THE FLASHER SOUNDER UNIT.
Status LED
LED
Status
Red & Green alternate flashing
Power Up Sequence
Green Flashing (30 sec interval)
Standby
Blue Flashing (30 sec interval)
Standby Master Device (Set 00)
Red Blinking
Low Battery
Blue Solid
Test Mode
Red Solid
Reset Mode
White Flashing
Alarm Mode
Green Rapid Flashing
Out of Range
Red Rapid Flashing
Out of Range & Low Battery
Testing the System
Testing the system is easy. If you are using the system without a Base Station you will need to
purchase an Evacuator Secure Key Fob. To put the system in to Test swipe the fob over the Test
System Logo on the left hand side of the product on any device in the system. This will then turn the
Status LED Solid Blue on all of the linked Devices. You will then have to walk the site making sure all
LED's are blue. When you are happy all LED's are blue in the system you can swipe the Key Fob over