– 12–
Disconnect the Spirit ZigBee from the network before you remove the device. To do so, set your ZigBee
controller to the leave mode. The Spirit ZigBee should display “RES“ and the valve stem moves to the
mounting position. Should a Spirit ZigBee will not leave automatically, manually remove it from ZigBee
network (see 4.9 restoring the factory settings).
Now unscrew the union nut and remove the Spirit ZigBee from the valve.
Press the Boost, Plus and Minis button until the counter in the LCD has reached 10.
Only release the button when the LCD displays “RES”.
The reset will start shortly after the button has been released.
The LCD displays “PrP” and the valve stem moves to the mounting position.
2.
1.
Only use the factory reset if your primary ZigBee controller no longer exists or does not function for
other reasons.
PRP
RES
Boost button flashes red.
Release the button as soon as
the LCD displays RES.
Mounting position
is prepared
Node
XXX
removed
4.8 Removing the Spirit ZigBee
4.9 Restoring the factory settings
