_______________________________________
______________________________________
Instruction Manual MM850099 ed.02a
_________________________________________ 26 ________________________________________
I D - Na me : 9 9
Fig. 8.7.1C
It can be programmed from 00 to 99 through the <
UP
> or <
DOWN
> keys.
Load the set value in the memory by pressing the <2> key
•
The display will return to the original indication as per fig. 8.7.1.D.
CAL 1 0 0 5 6 Z mA
Fig. 8.7.1D
ATTENTION
IN ALL ABOVE PROCEDURE STEPS AVOID PRESSING KEYS <SELECT>, <ENTER>
OR
<0>.
T
HE ABOVE KEY COMBINATIONS SHOULD BE USED ONLY DURING THE CALIBRATION PROCEDURE
.
•
To exit the procedure press the <
OFF
> key.
8.7.2
Digital output wiring practice
The wiring to the digital output signals is made through a mini connector mounted on the lower end of
the case.
The pertinent connections are indicated in fig. 8.7.2.A:
Tx
Vcc
GND
Rx
Front view
SERIAL CONNECTOR SIGNALS UniCal
8.7.3
Adaptor ( TTL to RS 232 )
