Eurotrac W11E, Руководство по эксплуатации

Страница: 13 / 72

Page 13/72
October 2019 W11E | Operation manual
There are four LED indications on the left side of the instrument cluster. When the switch is operated, the
corresponding indicator will be displayed:
Instrument working process and instructions for use:
1. Turn on the key switch; the dashboard is switched on, some initial digital mode will be displayed for 3 seconds.
The dashboard states the speed indication content, the power indicator, the steering angle indication, the hand
brake indication, the seat switch indication, the E/S/H selection indication, the working time, and the like.
These pattern data will help confirm the vehicle's working status.
2. The top of the left row of the LCD screen is the fault indication. When this indicator is on, the following three
working states are displayed:
-
Display normal operation (lights when the system switch is on or off).
- The meter is not connected to the control box (the indicator lights up after the connection stops for 3
seconds).
- The meter is not working (the indicator is on).
When the vehicle is working normally, there is no fault code and the fault light is off.
3. When the direction indicator is turned forward and backward, the left and right turn mark lights flash, and
when the headlights are turned on, the light indicator lights.
By pressing the E-S-H button, you can set the operating mode for your system (E-
Economy, S-Middle Mode, H-High Mode)
H-up mode : At this time, the acceleration, deceleration rate and maximum grade of
the vehicle are higher. It is suitable for transporting a large amount of cargo and
climbing a steep slope in a short time, but it costs electricity, unless it is urgently
needed, it usually does not work in this mode.
S-mid-range mode : Each indicator is slightly lower than the high-end mode.
E-Economy : All parameters are optimized, power saving, it is recommended to work
in this mode.
1. When the key switch is activated, press the enter button for 3 seconds to enter
the adjustment and diagnosis mode.
2. During the operation, press for 3 seconds to enter the diagnostic mode.
3. If you press enter once in the diagnostic mode, you can exit, and the enter key
is usually used as the new parameter value.
1. Press this button to decrease the parameter value in the adjustment or
diagnosis mode.
2. In the adjustment state, the display parameter value can be reduced.
3. Press the button for 1 second to display the mileage or weight.
Note: The up button is the same as the down button. Some functions of the enter
button and the up and down buttons are not activated.
Warning sign: LED shows red
Light identification: LED display green
The steering switch is turned on, the turn signal indicator is activated, and the LED
flashes green.
Brake fluid low: LED red alarm (optional)