Standard Procedure:
CONDITION 1 – Connection to your vehicle battery – normal status
Step One
Connect the smart clamps with your flashlight (blue parts) and the clamps
(black and red) with your vehicle battery in no particular order. But make sure
that the red terminal is connected to the positive pole of the vehicle battery and
the black terminal to the negative pole of the vehicle battery.
Step Two
Try to start the engine, if red and green lights on Ai clamps are flashing
alternately after successful connection and good contact. Turn the key to
position ACC, the dashboard will light up. Try to start your vehicle. If your car
is operated by “Starting-Button” to start the engine, push the Start-Engine-
Button. Green light is left only, if the engine is started successfully. Wait for
about 30 seconds before you start a second try of starting in case your first
attempt failed.
Step Three
After successfully started your vehicle, disconnect the clamps from your
vehicle battery in no particular order. Remove the intelligent clamps from the
power source of your flashlight. Store everything well and recharge your
flashlight.
CONDITION 2 – Special case - Connection to your vehicle battery is removed, gets lost. Be
sure you always properly connect the smart clamps to the positive and negative output wires,
to prevent this case.
Step One
Pay attention to which connection is not properly tightened. First remove the
loose connection. Then reconnect the positive terminal, which is connected to
the power source, to your positive battery pole, and then reconnect the
negative terminal, which has come loose from the battery pole, to the negative
output wire.
Step Two
Turn the key to position ACC, the dashboard will light up. Try to start your
vehicle. If your car is operated by “Starting-Button” to start the engine, push
the Start-Engine-Button
Step Three
After successfully started your vehicle, disconnect the clamps from your
vehicle battery in no particular order. Remove the intelligent clamps from the
power source of your flashlight. Store everything well and recharge your
flashlight.
ALARM AND GUIDES:
FUNCTION
LED
BUZZING
STATUS
Insert the blue plug
of intelligent clamp
into the blue
connection at the
flashlight
RED and GREEN
LED in black case
of the clamps are
alternately
flickering
---
Waiting status
