GB
Temperature settings:
With the on/off- and powerswitch you can select from two temperature settings. Depending on the application, you can
use the following settings:
Setting I 60 °C (venting / cooling)
Setting II 650 °C (weed burning / ignition BBQ or fire place)
The volume of air in each setting 500 l/minute
Start to use
Option 1: Weed killer:
If using the device as a weed killer you must use the extension tube and the handle. Hold the weed killer firmly by holding
the end of the extension handle.
Check that all of the relevant safety measures have been implemented.
Ensure the extension handle is firmly fixed onto the device and that the device is turned off.
Lead the electrical cable away from the burner nozzle through the cable clamps on the extension tube and handle.
Install the nozzle to destroy weeds.
Insert the plug into the socket
Check to ensure the nozzle is not blocked before turning the device on.
Slide the on/off and power switch to position II: the device will start to work.
Allow the device about 45 seconds to warm up.
To eliminate weeds, hold the nozzle over the weeds for about 5 seconds. During these 5 seconds the cell structure
of the weed is destroyed. As a result, the weed dies within a few days.
It is not necessary to completely burn the weeds, 5 seconds is more than sufficient.
For an efficient treatment the nozzle should be held around 0 to 5 cm above the weeds
You switch the device off (temporarily) by sliding the power switch back to 0.
The effects are not visible immediately but will take a while before they can be seen. It is more of a long-term effect.
Option 2: Lighter bbq / fire place:
The BBQ and fireplace lighter is always to be used without the extension handle.
Attach the BBQ nozzle onto the device
Place the nozzle under the coal or the wood.
Ensure that the firelighter is properly positioned
Insert the plug into the socket
Check to ensure the nozzle is not blocked before turning the device on.
Slide the on/off and power switch to position II: the device starts to work.
Remove the device from the coals or the wood as soon as it starts to glow
Now blow hot air into the coals or the wood from a distance of around 10
– 20 cm, until the coals or wood is burning
properly.
Doing this will help to avoid damaging the nozzle attachment. Exposing the nozzle to high temperatures for a
prolonged period of time could cause the materials to melt. Please follow these instructions to achieve long-term
enjoyment with the product.
Always use with caution! Do NOT cover the ventilation openings during use as it causes a risk of burns!
Never touch the hot nozzle!