Eurotech ED-GC604SS, Быстрый старт

Страница: 8 / 16

8
2. Place Burner Box
Apply the adhesive sealing tape to the underside lip of the burner box. Shown at G opposite.
Place burner box into cutout hole and fit clamping brackets to clamp the hotplate to the bench.
3. Fit Burners And Trivet.
Replace burners and ensure they are correctly repositioned over the ignitor (S) and thermocouple (T). The ignitor
(S) must be clean for trouble free sparking. Test burner ignition and burner flame for correct operation, If burner
is placed correctly it will not rotate on its supports
.
.
The Triple Ring (Wok) burner (diagrams below) does not fit over the igniter or thermocouple but must be placed
on its supports. Make sure trivet is fitted onto its locator on burners and c
an’t rotate after assembled.
3. Electrical Connection
Install a 10 amp general purpose outlet (GPO) in accordance with relevant electrical standards and/or codes of
practice applicable.
The power supply cord (supplied) must not touch against any hot surfaces and must be placed so that its
temperature does not exceed 75
℃
at any point along its length.
After having installed the hotplate, the GPO must always be in an accessible position.