User manual TOM600
Item partnumber : 61-200-0600
3
1. Description
The surface resistivimeter EUROSTAT TOM600 is suitable very well for the mobile use in industrial areas
through its compact housing and through the battery power. It can also be used stationary with a plug power
supply.
Important:
Don’t use the AC-Adapter when rechargeable batteries are installed.
The EUROSTAT 600 is menu-controlled, has only two buttons and so it is very operator-friendly.
All parameters are shown at the LC - Display.
The included PC-Software is for remote controlled usage, and additionally measuring results can be
administered and processed.
The EUROSTAT TOM600 works with the voltage – current measure - principle.
To the transactions of the measurements anuses of tied-up Norm DIN EN 61340 / EOS-ESD 4.1/6.1 the
measuring time can be selected with the internal timer.
At Timer = ON the measurement values inclusive the air parameters can be stored in the internal EEPROM.
They don’t are deleted by switching off the unit. The values can be read out trough the PC-Interface at all
times.
Since the resistance values depend very strongly on the Humidity and the air temperature,
these influences are measured together with the resistance value.
So a reproducible measurement is given.
2. Operating
Instruction
2.1.
Start operation
The Surface resistivitymeter
EUROSTAT TOM600 is delivered with 4 x Mignon (AA) NiMH – Batteries,
and is directly ready to start. For charging the batteries and stationary operation use the enclosed plug power
supply only. be..
Generallys speaking, the programm choice is done with “B” knob and the validation with “A” knob.
Push on knob “B” “ON/OFF” to start and then knob “A””START” to start the measure directly.
•
The electrodes are connected to the corresponding sockets (s. legend) and place on the probe .
•
During the measurement of very high-ohm-resistors is to be kept that no influence effect is happen on
the measure input.
How to select the parameters :
After switching on, first the software version is shown
.
TOM 600 V3.0
©
KL/
03.2004
Provided the timer is „ON“, in the display appears press start. You can start the measure by pressing key
“A” start. The current resistance value and the timer attitude are shown afterwards.
*>2.0xE12
Ω
T=OFF**
Air: xx°C xx%r.F
.
If the timer should be turned off, immediately appears at the display:
>2.0xE12
Ω
T=OFF
