EUROPRO MINIJET 120, Руководство пользователя

Страница: 12 / 24

User manual - JETPRO 80, 100, 120 201902-338-ENG P12
5. USE OF THE MACHINE
5.1. PREREQUISITES
• The electric connection has to be 230 V - 16 A - 50 or 60 Hz with a 3 x 2,5 mm cable reel of 40m
maximum, completely unreeled .
• The selection of the working mode is done by pushing the button (6), the warning lights (L5) or
(L6) indicate the selected working mode. The display (A1) indicates the set value of the instruction
"PRIMING" or "SPRAYING" .
• In PRIMING mode, the display (A1) indicates the setting of the speed of the rotation of the pump in %.
• In SPRAYING mode, the display (A1) indicates the setting of the working pressure in % (100% = 80
bar on Jetpro 80 // 100% = 120 bar on Jetpro 100 and 120).
• In AUTO mode (warning light L3 is on), the starting up of the machine happens automatically in
SPRAYING mode when opening the lance (warning light L6 is on).
• Always carry out the starting up of the machine in PRIMING mode.
• During the starting up of the machine, it is important to respect the following stages mentioned below :
- turn the machine on
- push the button (1)
- set the display (A1) to 50 with help of the b/- (4) & (5)
- push the button (2) to verify the correct start-up
• After a prolonged standstill, it is possible that the pump might be blocked . If this is the case, proceed
by start and stop. Put water and stocking liquid into the tank. Alternately turn the pump forwards
and backwards for 5 second sequences. As soon as the engine starts to turn normally, the pump is
unblocked. Empty the water.
• On the JETPRO 120: check every month that the machine’s automatic lubricator is working properly.
The level of grease in the cartridge should decrease steadily . The absence of grease can seriously
damage the machine .
It is imperative to replace the automatic motor flange lubricator every 6 months.
5.2. STARTING UP
Work / Stop
• Once the machine is plugged in, the machine is in the stop mode, the display (A1) indicates "OFF"
and the display (B1) indicates the mains voltage .
• If "AU" is shown, unscrew the emergency stop button a quarter of a turn.
• One push of the button "ON/OFF" (1), the warning light (L1) lights up, the machine is ready to work.
• One push of the button "ON/OFF" (1), when the machine is ready to work (warning light (L1) is on),
the machine will switch off, the display (A1) indicates "OFF" (warning light (L1) is off)