202206-609-ENG
User manual - JETPRO 80 & 100
P11
4. USE OF THE MACHINE (continued)
4.2. STARTING UP - USE OF PLASTER/PAINT
1.
Put soapy water into the tank.
2.
Press the button (1) to switch the machine on.
3.
Open the spray-gun, without nozzle nor nozzle holder.
4. Set the pump speed to 30 using the buttons (4) & (5).
5.
Press the button (2), the screw at the bottom of the tank shall turn (if it does not turn, see procedure
4.1.)
6.
When the water comes out of the spray-gun, press the button (2) to stop the machine.
7.
Empty the water remaining in the tank by opening the drain valve (E).
8.
Pour the plaster or paint into the tank. If necessary, use a trowel or tool to push the product under the
grid to eliminate air bubbles. Always keep the product level in the tank above the grid.
9.
Still at speed 30, press the button (2) and wait until the product comes out of the spray-gun.
10. As soon as the product comes out of the spray-gun, press the button (2) again, then close the spray-
gun.
11. Install the nozzle holder and the nozzle adapted to the product used.
12. Set the pressure to 70 minimum using the buttons (4) & (5).
13.
Press button the (2), the machine runs for a few seconds and then stops.
14.
The machine is ready to spray, it will start automatically when the spray-gun is opened.
15. Adjust the pressure according to your needs using the buttons (4) & (5).
Remember to mix the product well before pouring it into the machine’s tank.
The machine is equipped with a safety system to prevent damage to the rotor/stator. If the
machine fails to reach its set pressure, it will automatically stop after 45 seconds. There are
two possible scenarios:
- The nozzle used is either too big or worn: reduce the nozzle size or replace it with a new one.
- The rotor/stator is worn out: reduce the working setpoint and plan to replace the rotor/stator.
