APPENDIX ONE
10
Remote Not Learning to Receiver
Begin
Verify proper 120VAC power supply
A. Remove the batteries from battery back up.
B. Attempt to light continuous pilot from switch. If pilot lights or if spark is present we know power is
supplied and we can proceed. If spark or pilot is not present proceed in troubleshooting steps for pilot does not
light. (if you now re
-
install batteries and the pilot turns on focus would be on main power supply which is ex-
plained later in the guide with voltage readings)
It is possible the integrated fireplace control (IDC) module is in a lockout position. See page 9 on lockout and reset
information.
Press the Red SW1 button the on the IFC module. You should
hear 3 fast beeps indicating the receiver box is ready to learn the
remote code. Did you hear the beep code?
Verify the ON/OFF rocker switch is
in the ON position. Attempt learn
sequence again. If no sound/LED
replace IFC module.
No
Yes
Quickly press the ON/OFF power button on the remote control.
You should now hear 4 beeps indicating the receiver has learned
the remotes unique programming code. Did you hear the beep?
Verify batteries are new in remote,
and if so replace remote control.
No
Yes
Remote is learned to the receiver and should operate the fireplace.
Proceed to next troubleshooting
tree to verify there is not another
problem
No
IFC
Confirm 120V AC connections
Begin
Remote/Receiver Not Synchronized
