Page 6
DV 52 ST See-thru Gas Fireplace
rev.110329
Installation
Installing Terminations with Built-In Frames
Installing Terminations with MSR Frames
12
12
1. Frame the termination opening to 12" x 12".
2. Fasten the termination to the studs using a minimum of 4 screws.
11
11
1. Frame the termination opening to 11" x 11".
2. Fasten the termination to the studs using a minimum of 4 screws.
Installing Terminations with MOSR Frames
12
12
12
MOSR
1. Frame the termination opening to 12" x 12".
2. Fasten the MOSR frame to the interior side of the studs using a minimum of 4
screws.
3. Insert the termination into the MOSR frame as shown here and attach by screwing
through the four pilot holes in the termination.
MSR
PTO-4 (5"/8")
PTO-4F (5"/8")
PTO-4 (5"/8")
PTKOG (5"/8")
1. Ensure that the two
long
mounting brackets are facing the bottom of the
termination. (See inset). This will provide more heat protection at the top of
the termination, where temperatures are highest.
2. Attach to the faceplate of the termination using four sheet metal screws.
3. If installing the termination over vinyl siding, use the VSS Vinyl Shield.
Installing Heat Guards over Terminations
Figure 6.
Installing the VSS Vinyl Shield.
Figure 5a.
Installing a PTO termination.
Figure 5b.
Installing a PTO termination with the MSR frame.
Figure 5c.
Installing a PTO termination with the MOSR frame.
Figure 5d.
Installing a PTO termination heat guard.
