Page 7
DV 38 Gas Fireplace
Installation
Section 3: Venting
Figure 7.
Flue cover and collar removal, top vented fireplace.
Figure 8.
Flue cover and collar installation, rear vented fireplace.
Section 3-1:
CONVERTING TO REAR VENT
Use the following instructions to convert a
DV 38
for rear vent
use:
1. Remove the rear flue cover and gasket (5" and 8") on the
flue outlet, as shown in
Figure 7.
2. Next, remove the top flue collars (5" and 8") on the flue
outlet, as shown in
Figure 7.
3. Install the (removed) rear flue cover and gasket material,
to the top vent outlet. Fasten the cover with included
hardware, as illustrated
Figure 8
.
4. Install the (5" and 8") collars to the rear vent outlet using
the included hardware, as illustrated
Figure 8
.
5” Inner Flue Collar
8” Outer Flue Collar
Flue Gasket
Flue Cover Plate
Flue Gasket
Flue Cover Plate
8” Outer Flue Collar
5” Inner Flue Collar
European Home supplies a variety of direct venting and
termination options.
The direct vent termination location
MUST be selected such that it is the highest point in the
venting assembly.
It should also be selected such that it
provides the shortest vent run possible. Should it be impossible
to ensure that the termination is the highest point or to meet the
venting guidelines laid out below please contact your European
Home dealer to discuss power venting options.
NOTES FOR PLANNING THE VENTING:
Venting can originate from the unit through the top or through
the rear.
Venting can terminate through the roof or through an exterior
wall.
Refer to Appendix A - Termination Locations to ensure the
planned termination location is acceptable.
Once the termination location has been established, refer to
the appropriate section below for installation details.
All fireplaces shipped from the factory are top vent.
See
Section 3-1
for converting the unit from top vent to rear vent.
