EUROPEAN FINISHING EQUIPMENT Hi-Steam EVG-35 Series, Инструкция по эксплуатации и безопасности

Страница: 7 / 27

7
D. CLEANING AND MAINTENANCE
Once a month (or more frequently if you have hard water), before the start of work when the
boiler containing old water is cold and unpressurized , (1) shake the boiler (to loosen debris
inside); (2) open the water cap and pour out old water; (3) rinse the boiler with fresh water, and
(4) refill the boiler with fresh tap water.
For EVG floor models, place a suitable container under the drain
valve. Loosen the water safety cap and turn the drain valve handle
counter-clockwise. Wait for all water to come out and then shut
the drain valve. (It may be clogged with dirt. In this case, use a
wire with a diameter 3-4 mm or similar to gently unclog it.)
E. IRONING OPERATION
1. Run the iron on garments, pressing the micro-switch of the iron for steam (Fig. 6). For delicate,
blue or black garments, use Teflon shoe.
2. For delicate, blue or black garments, use teflon shoe.
3. During ironing operation, always put the iron on its rubber iron rest (Fig. 1).
4. For dry ironing (with no steam), it is possible to adjust the thermostat (Fig. 5) on different
positions according to the type of fabric (look at garment label). For steam ironing, set the
thermostat on “cotton” or “linen”.
5. When Mini Boiler with Iron is used with a non-vacuum board, some circular water spots might
form. In this case, reduce the steam flow through the knob for steam adjustment (Fig. 3). It is
recommended to use the mini boiler with iron with a vacuum and heated ironing board.
Fig. 4
Fig. 5
Fig. 6
Drain valve