6
continue from ELECTRICAL INSTALLATION
T FUNCTION.
OT
PROCEDURE :
Insert the wall embedded cable through Side Entry ‘A’ by
cord rubber holder and lead the cable to Cable Bracket ‘B’. (Fig. 7)
Connect the cable as following:
BROWN or RED
-- LIVE (L)
BLUE or BLACK
-- NEUTRAL (N)
GREEN or GREEN/YELLOW
-- EARTH ( )
Clamp the cable to the correct position. CHECK IF THE WIRING CONNECTION IS CORRECT AND SECURE.
- Reinstall the cover.
When putting back the Front Cover, please take note of the procedure shown below :
The ‘’live’’ wires must be connected to the slots on Terminal Block marked L.
The ‘’neutral’’ wires must be connected to the slots on Terminal Block marked N.
The ground wire must be connected to the
at marked with the
3.
4.
Method of Alignment When Replacing Front Cover
Fig. A
Fig. B
R
rew ‘A’
5.
Terminal Block
Position
this way
(Off Position)
cutting a hole at the
source
ground symbol.
( )
TEST RUN
Turn on the water supply and Stop Valve, the wat
ow through the outlet.
Switch on the electrical supply. (LED indicator will light up in Blue Color)
Turn the Temperature Control Knob to ‘ON’, the LED Indicator will light up in Purple Color, hot water will
ow out within a few seconds. The more Temperature Control Knob being turned in clockwise direction,
the hotter is the water.
LED Indicator function :
The shower bath, long bath, wash basin might not be hot enought even at the ‘MAX’ position if
incoming water supply from the mains is too cold or the pressure of water is too high. In this case, you
may adjust the incoming cold water mixer valve to reduce the wat
ow in order to get the desired
water temperature.
It is unnecessary to turn the Temperature Control Knob to “OFF” position when the Heater is not in use.
Explain to the user how the unit works and familiarise him or her with its use.
- Advise the user about possible hazards (high water temperature)
- Hand over these instructions, to be kept in a safe place.
5.
6.
1) BLUE - ON
2) PURPLE - POWER ON
3) LED OFF - POWER OFF
Position
this way
(Off Position)
