11
Hang the heater onto the wall support. The bracket at the back of the heater unit must fall
into the curved part of the wall support; the hanging screw (7) must be placed into the round
part of the ‘keyhole’ on the wall support and then pushed gently downwards until the patio
heater is firmly affixed. Secure this with a bolt through both brackets (see diagram).
Check that the patio heater is attached firmly and fully horizontally before use.
Assembling the stand (only S version):
Place the bottom section of the stand (9, with the
fastening plate) on the base (8), in such a way that the
screw holes are aligned. Turn the foot over and screw
the lower section of the stand from below with the plate
and the locking nut (see diagram).
Turn the base the
right way up.
Insert the 3 bolts through the double holes and tighten
them firmly. Place the protective cover over the screw
connection.
Slide the adjustable, narrow section of the stand (12) from below through the top section of
the stand (11), until it comes out again at the top (widening at the base). Secure the
adjustable section using the black locking screw (15) that is located at the top of the top
section of the stand.
Push the centre section of the stand (10) into the lower section (9), screw-hole to screw-hole.
Secure with four fixing screws. In the same way, secure the upper section of the stand (11,
with the adjustable part inside) over the central section.
Screw the separate cable guide (supplied) to the adjustable section of the stand, so that it
cannot slide into the upper section.
Then undo the hanging screw (7) almost entirely. Place the top of the patio heater over the
top of the adjustable stand section so that the hanging screw falls precisely into the recess
on the stand.
Now tighten the screw firmly. The electrical cable can be secured in the cable holders on the
stand.
Check that all connections are completely secure and that the terrace heater is securely
positioned before using it.
The terrace heater must be placed at a distance of at least 1 metre from the nearest wall.
The box with the radiator lights must be at least 30 cm from a ceiling and 1.80 metres above
the ground. The terrace heater must be placed firmly on an even and completely horizontal
surface.
PATIO HEATER FUNCTIONS
The top of the patio heater can tilt to around 35°; set it to the position you prefer.
The height of the heater top can be adjusted with the S-system. The black locking screw (15)
on the upper stand section must be undone and the adjustable stand section can be pushed
in/out of the upper section. Then tighten the screw up firmly. The heater head must always
be kept at least 180 cm above the floor.
Check that all of the safety requirements have been fulfilled.
Now insert the plug into the socket (230V-50Hz).
By pressing one of the two operating switches (I pressed), you can set the patio heater to
half power (1000W). By pressing the other switch in too, you can also switch the second light
on and the device works at full power (2000W). Switch off the lamps by pressing the
switches again (O pressed).
