EUROM 334579, Инструкция по эксплуатации

Страница: 29 / 144

29
 For personal protection the installation, to which the Eurom Heat and Beat is
connected, has to be equipped with an earth fall device (max. 30 mAmp). Only
connect the heater to an earthed socket!
Under some circumstances it may be attractive to make a fast connection between
the heater and the main supply, and to operate the heater with a switch. Because
the Eurom Heat and Beat has a high water tightness (IP65) and for safety reasons,
such a connection has to be made by a qualified electrician.
Working
Check for every use:
- or the appliance doesn’t show signs of damage.
- or the appliance still is fastened firmly. Mechanical bearing pressure, oscillating
duet o wind or rain could lead to loose.
- or there are no objects, canvas, sun screens etc. are inside the safety distances.
- or the socket you want to use gives the correct tension (220-240V~50Hz) and is
grounded.
If everything is all right you can insert the plug into the socket.
The Eurom Heat and Beat
has a remote control that works with two batteries: AAA,
1.5V.
While using, point the remote control to the receiving point of the heater. If there
are obstacles between remote control and the heater, it will not work! The
commands from the remote control to the device can cover a maximum distance of
6 metres.
 Press the on/off switch (5) on the side of the unit to "I"
(on); The blue light on the reception point will go on.
 Set the device into operation by pressing the ON button
of the remote control. The device has a ‘slow start’ at
33% output. 4 seconds after starting, it automatically
switches to the most recently used output. On first use, it
will switch to 100% output after 4 seconds.
 By pressing you can switch to a higher heating level.
 By pressing you can switch to a lower heating level.
 By pressing (briefly) you can switch the speaker on
(or off).
By pressing this button for longer you can initiate the
Bluetooth connection for the speakers.
 By pressing you can switch on the LED lighting.
 By pressing you can switch off the LED lightning.
 To stop the unit, first press the 'off' button on the remote
control. Then turn it off by pressing the on/off-switch (5) to ‘O’ (off). Finally,
unplug it from the wall outlet. Allow the heater to cool down.