EuroLite WLF-1500 Water Low Fog PRO, Руководство пользователя

Страница: 20 / 24

20 • EN
Timer Mode
In the timer mode, the fog machine will automatically emit fog. The time intervals, duration and fog volume depend
on the corresponding menu settings. Press the
TIMER button, to activate the timer mode. The display indicates
the set time interval. The unit counts down to 0 seconds and emits fog. To deactivate the timer mode, press the
TIMER button again.
Continuous Mode
Press the VOLUME button, to activate continuous fog output. The display indicates Volume followed by the value
that was set in menu item “ Volume Out ” or “ NONSTOP BURST ” if maximum fog volume was selected. To stop
the fog output, press the VOLUME button once again.
Manual Mode
For immediate fog output at the maximum volume of fog, keep the MANUAL button pressed. The display
indicates “ Manual 100 % “. As soon as you release the button, the fog output will stop. The manual operation will
take priority over the continuous operation and the timer operation. Even if one of these operating modes is
activated, the fog machine will always emit the maximum volume of fog when the
MANUAL button is pressed.
Wireless Remote Control
Press the left button on the remote control to emit fog (continuous
operation with 100 % fog volume). The control LED between the two
buttons lights up. To stop the fog output, press the right button.
If necessary, the wireless remote control can be turned off in the menu.
If the remote control is not working properly, it must be assigned to the unit.
The remote control can be assigned during a short period of time after
switching on the machine as long as the display shows the following
indication:
To assign the remote control, press and hold one of the buttons until the
display flashes repeatedly, to indicate a match. This can take up to 12
seconds. Thus, the remote control has been assigned to the machine and
may be used for wireless control.
DMX512 Control
The unit features 3-pin or 5-pin XLR plugs for DMX connection.
1
Connect the output of your DMX controller to the DMX input DMX IN of the machine with a DMX cable.
2
Connect the DMX output
DMX OUT
of the machine to the DMX input of the next unit in the chain. Always
connect one output to the input of the next unit until all units are connected.
3
At the last unit, the DMX cable has to be terminated. Plug the terminator with a 120 Ω resistor between Signal
(–) and Signal (+) in the DMX output of the last unit.
4
If the cable length exceeds 300 m or the number of DMX devices is greater than 32, it is recommended to
insert a DMX level amplifier to ensure proper data transmission.
Occupation of the XLR connection: