17
•
EN
OPERATING ELEMENTS AND CONNECTIONS
Tank
Circuit breaker
Fluid hose
Power output
Display and operating buttons
Ventilation slits
5-pin XLR connectors
Output nozzle
3-pin XLR connectors
SETUP
Filling up fog fluid
WARNING!
Fluid handling
Always disconnect from the mains before filling the machine. Only use water-based fluids. We
recommend high-quality Eurolite fluids. Never add flammable liquids. If fluid gets inside the machine,
have it checked by skilled personnel before it is operated.
Unscrew the tank cap and fill the tank with fog fluid. Tightly close the tank again.
Placing the unit
•
Remove all packing materials from the shipping box. Make sure that there are no packing remnants at the fog
output nozzle.
•
Install the device in a well-ventilated area. The operation in an insufficiently ventilated room can lead to a
condensation of the fog fluid. The resulting slippery surface can cause accidents.
•
To prevent overheating the device, ensure that the ventilation slits are not covered and that air can circulate
freely.
•
Keep a minimum distance of 20 cm around and above the device.
•
Only install the fog machine on scratch resistant and water resistant surfaces (inclination angle max. 15°).
•
Do not orientate the escape nozzle directly in the direction of the audience's eyes. In order to create a good
effect, there should be a distance between the device and the audience of at least 1.5 m.
•
All fog machines develop condensation around the output nozzle. Because this may result in some moisture
accumulation on the surface below the output nozzle, consider this condensation when installing your unit.
TIMER
VOLUME
STOP
MENU
ENTER
BREAKER
POWER IN
230V~ 50Hz
OUT
IN
DMX
N-1 0
3
Tour Fogger
HOT NOZZLE!
ACHTUNG!
NIEMALS ENTFLAMMBARE FLÜSSIGKEITEN EINFÜLLEN.
CAUTION!
NEVER ADD FLAMMABLE SUBSTANCES.
8A/250V
1350W
