00037124.DOC, Version 1.2
19/22
OPERATION
After you connected the spot to the mains, the EUROLITE LED Z-500 / LED Z-600 RGBW DMX starts
running.
This unit has three operating modes. It can be run in Stand Alone, Auto or DMX-controlled Mode.
STAND ALONE OPERATION
In Stand Alone Operation you can use the LED Z-500 / LED Z-600 RGBW DMX without a controller.
For sound controlled operation set all DIP Switches to OFF.
You can do without a controller as the LED Z-500 / LED Z-600 RGBW DMX features a built-in microphone,
which provides automatic sound control. You can adjust the sensitivity with the rotary-control on the
rearpanel.
AUTO MODE
In order to Auto Mode, set DIP switch 9 to ON and 10 to OFF.
Speed can be adjusted via DIP switches 4 to 8.
If DIP switches 4 to 8 are set to OFF, the internal programs run at highest speed.
If DIP switch 4 is set to ON, the internal programs run at a bit slower speed.
If DIP switch 5 is also set to ON, the internal programs run at an even slower speed.
When DIP switch 8 is set on ON, the internal programs run at the slowest speed.
DMX-CONTROLLED OPERATION
You can control the spots individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.
For DMX-controlled operation set DIP Switch 10 to ON.
Addressing
Each device occupies 7 channels. To ensure that the control signals are properly directed to each device,
the device requires addressing. This is to be adjusted for every single device by changing the DIP switches
as set out in the table below.
The starting address is defined as the first channel from which the device will respond to the controller.
Please make sure that you do not have any overlapping channels in order to control each device correctly
and independently from any other fixture on the DMX data link. If two, three or more devices are addressed
similarly, they will work similarly.
Occupation of the DIP-switches:
