00054285, Version 1.3
27/30
DMX-controlled operation
You can control the projectors individually via your DMX-controller.
Every DMX-channel has a different occupation with different features. The individual channels and their
features are listed under DMX-protocol.
Addressing
The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the LED TMH-10 Spot will respond to the controller.
If you set, for example, the address to channel 13, the device will use the channel 13 to 24 for control.
Please, be sure that you don’t have any overlapping channels in order to control each LED TMH-10 Spot
correctly and independently from any other fixture on the DMX-chain.
If several LED TMH-10 Spot are addressed similarly, they will work synchronically.
Press the Up/Down-buttons for setting the desired starting address. Now you can start operating the LED
TMH-10 Spot via your lighting controller.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data
is received, the DMX indicator will be flashing. If there is no data received at the DMX-input, the DMX
indicator does not light up.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It’s necessary to insert the XLR termination plug (with 120 Ohm) in the last device in the link in order to
ensure proper transmission on the DMX data link.
DMX-protocol
Control-channel 1 - Horizontal movement (Pan) (within 585°)
Push slider up in order to move the head horizontally (PAN).
Gradual head adjustment from one end of the slider to the other (0-255, 128-center).
The head can be stopped at any position you wish.
Control-channel 2 - Vertical movement (Tilt) (within 270°)
Push slider up in order to move the head vertically (TILT).
Gradual head adjustment from one end of the slider to the other (0-255, 128-center).
The head can be stopped at any position you wish.
Control-channel 3 - Pan/Tilt-speed
Decimal Hexad. Percentage S/F
Feature
0 255 00 FF
0% 100%
F
Decreasing speed
Control-channel 4 - Colour-wheel
Linear colour change following the movement of the slider.
In this way you can stop the colour-wheel in any position.
