00083282, Version 1.0
20/23
MODE UP DOWN ENTER
Connection with the mains
Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable
Pin
International
Brown
Live
L
Blue
Neutral
N
Yellow/Green
Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.
Connection between devices
On the rear panel, there is an IEC socket (Power Out). Connect the output with the input of the next fixture
until all fixtures are connected.
Attention:
It is recommended to renew the connection with the power mains after every
8
devices.
OPERATION
After you connected the EUROLITE LED SLS-503 TCL 5x3W Floor to the mains, the device starts running.
The LED display lights up and you can now choose the desired settings via the buttons MODE, ENTER, UP
and DOWN.
The device has two operating modes. It can be operated in stand-alone mode via the control board or the
EUROLITE IR-4 remote control or in DMX-controlled mode via any standard DMX controller
Control board
The control board offers several features, i.e. setting the DMX starting address,
running a preset program or selecting a DMX channel mode.
Browse through the menu by pressing MODE. You can change the selection by
pressing UP or DOWN. Press ENTER in order to confirm. You can leave every
mode by pressing MODE. The functions provided are listed in the following
sections.
-
STAND ALONE MODE
-
Setting Solid Colors
-
Auto Mode
-
Sound Control / Sensitivity
-
DMX MODE
-
3CH or 5CH selection
