00048513.DOC, Version 1.1
25/26
Addressing
Depending on the DMX-mode, each device of the LED PAR-64 RGBA, 10mm occupies 4 or 6 DMX-
channels. The Control Board allows you to assign the DMX starting address, which is defined as the first
channel from which the LED PAR-64 RGBA, 10mm will respond to the controller.
Please, be sure that you don’t have any overlapping channels in order to control each LED PAR-64 RGBA,
10mm correctly and independently from any other fixture on the DMX-chain.
If several LED PAR-64 RGBA, 10mm are addressed similarly, they will work synchronically.
Note:
It’s necessary to insert the XLR termination plug (with 120 Ohm) in the last device in the link in order to
ensure proper transmission on the DMX data link.
CLEANING AND MAINTENANCE
Disconnect from mains before starting maintenance operation!
DANGER TO LIFE!
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.
Replacing the fuse
If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1:
Unscrew the fuseholder with a fitting screwdriver from the housing (anti-clockwise).
Step 2:
Remove the old fuse from the fuseholder.
Step 3:
Install the new fuse in the fuseholder.
Step 4:
Replace the fuseholder in the housing and fix it.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by authorized dealers only
in order to avoid hazards.
Should you have further questions, please contact your dealer.
