29
•
EN
Deleting a memorized standard speed
1
Be sure the Sound control mode is disengaged. The Audio LED is off.
2
Select your program as described above.
3
Move the
Speed fader
to the
SHOW MODE
position. Then tap the
FLASH
button (25-48) while pressing and
holding down the
REC SPEED
button. The corresponding program will not run with the standard speed any
longer.
4
Now you may move the
Speed fader
to select your desired speed.
Changing the speed mode from 5 to 10 minutes
1
Press and hold the
RECORD
button.
2
Tap the
FLASH
button 5 or 10 three times while holding down the
RECORD
button.
3
The
5 MIN
or
10 MIN
LED should light up indicating the Speed fader is set to run in the 5 or 10 minute mode.
GENERAL FUNCTIONS
Reverse the direction of chase programs
1
Reverse the direction of all the scenes. Press the
ALL REV
Button, all scenes should change their directions.
2
Reverse the chasing direction of all programs currently running: Press the
CHASE REV
button.
3
Reverse the chasing direction of all the programs with memorized standard speed: Press the
BEAT REV
button.
4
Reverse chasing direction of a particular program. Press and hold down the
REV ONE
button, then press
down the
FLASH
button corresponding to your desired program and release together.
Fade time
1
The fade time is the amount of time that it will take for the dimmer to go from zero output to maximum output,
and vice versa.
2
Fade time is adjusted through the
Fade
Fader
, which varies from instant to 10 minutes.
TAP SYNC button
1
Be sure the Sound control mode is disengaged. The Audio LED is off.
2
The
TAP SYNC
button is used to set and synchronize the chase rate (the rate at which all scenes will
sequence) by tapping the button several times. The chase rate will synchronize to the time of the last two taps.
The LED above the
STEP
button will flash at the new chase rate. The chase rate may be set anytime whether
or not a program is running.
3
Tap
TAP SYNC
will override any previous setting of the speed fader control until the fader is moved again.
Master fader
1
The Master Fader control provides proportion level control over all channels and scenes with the exception of
the Flash Buttons.
2
For example: Whenever the Master fader control is at minimum, all stage outputs will be at zero except for any
resulting from a FLASH button or FULL ON button. If the Master is at 50%, all outputs will be at only 50% of the
setting of current channel or scenes except for any resulting from a Flash button or FULL ON button. If the
Master is at full, all outputs will follow the unit setting.
3
Master fader A always controls outputs of channels 1-24. Master fader B controls the programs or scenes
except in Double Preset mode.
Single mode
1
All chase programs will run in sequential order starting in the order of program number.
2
The display will read the running program number.
3
All programs will be controlled by the same Speed Fader.
4
Press the
MODE SELECT
button and select
CHASE/SCENES
mode.
5
Press the
PARK
button to select
SINGLE CHASE
mode. A red LED will indicate this selection.
Содержание 70064545
Страница 1: ......
Страница 2: ......
Страница 6: ...6 DE BEDIENELEMENTE UND ANSCHL SSE...
Страница 21: ...21 EN OPERATING ELEMENTS AND CONNECTIONS...
