Eurochron 1486096, Руководство по эксплуатации

Страница: 46 / 108

b) Temperature alarm
In "Temperature alarm", you can set the limits ("Maximum" and
"Minimum") that will trip an alarm later during the measurement.
The range can be set according to the measurement range of the
respective device. When making the setting, observe that the high-
er value under "Maximum" is complied with. You can also select
the measuring unit "degrees Celsius" (°C) or degrees Fahrenheit
(°F). Confirm your settings with "done". The display will switch
back to the setting screen (figure 5).
During the later measurement, the value "Maximum" will be dis-
played with a red line in the graphical display. The value "Mini-
mum" is displayed with a blue line. When a set limit is exceeded
or undercut, the thermo logger as well as the mobile end device
will issue a warning signal. The mobile end device will additionally
show a display for the event. The individual measuring results are
displayed as a line in a selected time line.
The current temperature is displayed in the upper area of the dis-
play on the mobile end device. While a measurement is started, this
display can show the average temperature when scrolling to the left,
and the lowest and highest temperatures when scrolling to the right.
c) Test range
This function cannot be selected in the present devices and shows
only the measuring size ("Temp" = Temperature) for a long-term
measurement.
d) Testing the interval settings
In this function, you can activate up to three measurement ranges
that can be viewed in the function displayed below "Section / test
range" and also set individually. If you select "1", you can set a
temperature range with a scan rate. If you select "2" or "3", you can
activate one to three measurement ranges with different values.
46